Casablanca Hanover Manuel du propriétaire Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
HANOVER
TIP: e downrod has a tapered thread that is designed
to lock completely when installed correctly.
Step 6c. Using the provided Allen wrench (attached to the
paper motor warning shield), remove the Allen set screw
from the hanger adaptor and set it aside. Insert the downrod
into the motor coupling and turn it clockwise until it stops
turning, ensuring that the pole has bottomed out.
Step 6d. While holding the adaptor motor cover securely,
insert the set screw and tighten it with the provided Allen
wrench to ensure safe operation of your fan. If it is tight
enough, you should not be able to turn the downrod
counterclockwise with your hands. If in doubt, tighten
the set screw with the Allen wrench until you cannot turn
it any further.
Motor Wires
(leave at least 6" long)
Ground Wire
(green)
Perma•Lock™ Downrod
and Ball Assembly
Tapered thread
Allen Wrench
Allen
Set Screw
Motor Housing
Assembly
Motor
Coupling
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod and
fall during normal operation.
Install Incandescent Lightbulbs
Step 7. Screw in four 25-watt incandescent lightbulbs as
shown.
NOTE: When replacing lightbulbs, be sure to use only
25-watt maximum.
Caution Shield
HANGING THE FAN
Step 8a. To hang the fan body in the canopy, hold the fan
body fi rmly and insert the ball into the canopy opening.
Check that no wires were pinched. Rotate the fan body
until the slot in the ball fi ts into the pin opposite the
canopy opening.
Step 8b. Trim excess motor wires, leaving at least 6 inches
above the downrod. Strip
1
/
2
-inch insulation from the end
of each wire using a wire stripper (available at your local
hardware store). e splices after being made should be
turned upward and pushed carefully into the outlet box.
Ball
Slot
Pin
FAN PREPARATION (CONT.)
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire