Casablanca Hanover Manuel du propriétaire télécharger pdf (Page 11)

HANOVER

™

Send Signal

LED

Fan Control

To start the fan. Press the selected speed button to run the fan at the desired speed.

LOW=Low speed MED=Medium speed HIGH=High speed

To turn oﬀ the fan, press the FAN OFF button.

Airﬂ ow Direction

To reverse the airﬂ ow, press the REVERSE button. REVERSE operates at any speed

whether the fan is on or oﬀ .  e fan returns to its set speed after reversing.

Light Control

Turn the light on or oﬀ independently from the fan by pressing the LIGHT rocker switch.

(Press the left side for the uplight, right side for the downlight, and the middle for both.)

If you press the button for more than 0.7 seconds, it becomes a dimmer.  e light varies

from “bright" to “dim” over approximately 8 seconds. If you continue to hold the LIGHT

button, this sequence will reverse when the light reaches its brightest or dimmest level.

Release the button when the desired level is reached.

Auto Resume

Quick (pressing less than 0.7 seconds) on/oﬀ operation of the LIGHT button maintains

the desired brightness level set previously.

If the fan is not functioning after installation:

Step 1. Check to make sure that batteries are installed correctly

in the control.

Step 2. Turn the power oﬀ to the fan (from the circuit breaker)

for at least 5 seconds.

Step 3. Turn the power back on (at the circuit breaker) and push

the HIGH, MED, and LOW buttons–in that order–within 20

seconds.  e fan should now function properly.

CHANGING TRANSMITTER FREQUENCY SETTING

You will only have to change the dip switch settings in the remote

if you are using more than one fan in the same area and want to

control them separately.

Step 1. At the circuit breaker or fuse box, turn the power oﬀ for

the fan you want to change.

Step 2. Open the battery door of the Versa•Touch control and

remove the batteries.

Step 3. Change the dip switch settings, assuring that they are

diﬀ erent from the previously installed Versa•Touch fan.

Step 4. Reinstall the batteries and the battery door on the

control.

Step 5. At the circuit breaker or fuse box, turn the power back on

for the fan whose frequency you are changing.

Circuit Breaker

or Fuse Box

Press in this order to set new

frequency:

1. HIGH 2. MED 3. LOW

Dip Switch

set to “01001”

Dip Switch

set to “10000”

Versa•Touch 2

Control

(back)

LOW

MED

HIGH

DOWNLIGHT

FAN

OFF

REVERSE

Note: You may want to label your controls to assure you

do not mix them up.

REMOTE OPERATION

WAR NI NG!

Do not turn the power oﬀ at the circuit breaker, then

back on, for the previously installed Versa•Touch2

fan(s), as you may inadvertently change the

frequency settings for it as well.

Note: All fans leave the factory set to “00000.”

UP-

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Casablanca Hanover Manuel du propriétaire Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages Casablanca Hanover